{"id":3624,"date":"2024-08-05T01:51:00","date_gmt":"2024-08-05T01:51:00","guid":{"rendered":"https:\/\/www.jammersignal.com\/?p=3624"},"modified":"2024-07-16T09:21:51","modified_gmt":"2024-07-16T09:21:51","slug":"pay-attention-to-when-installing-cell-phone-jammer","status":"publish","type":"post","link":"https:\/\/www.jammersignal.com\/es\/pay-attention-to-when-installing-cell-phone-jammer\/","title":{"rendered":"\u00bfQu\u00e9 debo tener en cuenta al instalar un inhibidor de se\u00f1al de telefon\u00eda m\u00f3vil?"},"content":{"rendered":"\n

In recent years, mobile phone signal jammers have become more and more common in our daily lives, but it is important to understand how to properly install and assemble mobile phone signal jammers to ensure their effective application.<\/p>\n\n\n\n

A typical cell phone jammer<\/a> consists of several components, including a server, a wireless antenna, and an adapter. During installation, it is critical to keep a strong electromagnetic field connection within a certain distance (usually 20-30 cm) between the server and the antenna. In addition, there is also a strong electromagnetic field near the 220V power plug (weak current) (usually 5-10 cm). These electromagnetic fields will have an impact on the assembly and placement of components. Improper placement will result in impaired signal transmission and reduced shielding effect.<\/p>\n\n\n\n

\"world<\/a><\/figure>\n\n\n\n

The recommended installation intervals for each component of the mobile phone signal jammer<\/a> are as follows:<\/p>\n\n\n\n

    \n
  1. The adapter should be at least 20 cm away from the server. If the installation conditions on site make it difficult to maintain the power supply distance, the adapter can be placed under the signal jammer server. Although the adapter will still be affected by the magnetic field of the mobile phone jammer using this method, the impact will be much smaller than placing the adapter close to the sides of the server.<\/li>\n\n\n\n
  2. There should be no weak wires (AC220V) within 20cm around the antenna, including avoiding weak wires near the upper and lower sides of the antenna, the top of the antenna, and the embedded part of the wall where the antenna is located. If the recommended distance cannot be maintained, try to keep the weak wires at least 10cm away from the antenna.<\/li>\n\n\n\n
  3. The ideal installation height of the jammer is not less than 1.8 meters.<\/li>\n<\/ol>\n\n\n\n

    When the safe zone is less than 200 meters away from the communication base station, the shielding effect is inversely proportional to the distance from the base station, that is, the closer to the base station, the smaller the shielding radius. Popular GPS jammer<\/a> and WIFI jammer<\/a> in Europe and America.<\/p>\n\n\n\n

    \"world<\/figure>\n\n\n\n

    Before inserting the device, make sure that the wireless antenna is firmly tightened. The wireless antenna should be upright (vertical) (\u22a5). The data marked on the wireless antenna must correspond one by one to the data marked on the wireless antenna hole on the server. Avoid plugging the antenna in reverse and make sure not to disconnect the wireless antenna while turning on the jammer power.<\/p>\n\n\n\n

    By following these installation and assembly guidelines, you can effectively activate the application of the mobile phone signal jammer and ensure its optimal performance.<\/p>\n\n\n\n

    <\/p>\n\n\n\n

    Best Selling Signal Jammers<\/h5>\n\n\n